Troubleshoot Device Detection and Selection

If a storage device does not appear in DriveErase or cannot be selected, start by confirming that Windows can detect the hardware. Device discovery depends on the storage connection, installed drivers, controller configuration, and the information exposed by the device.

Do not attempt to work around a missing device by guessing its physical-drive path or selecting another disk with a similar capacity.

Device not detected

Check that the device is powered on, properly connected, and visible in Windows Device Manager or Disk Management.

For an external drive, try a reliable cable and a different suitable port. If the enclosure has its own power supply, verify that it is connected and functioning.

For internal SATA, SAS, or NVMe devices, confirm that the drive is correctly installed and recognized by the computer’s firmware or storage controller.

If Windows detects the device but DriveErase does not, use Scan Devices to refresh the list. If it remains missing, examine whether a RAID controller, HBA, storage bridge, or virtual storage configuration is preventing it from being exposed as a supported target.

Generic or incomplete identity information

Some storage adapters report generic information rather than the underlying drive’s actual model or serial number.

This is particularly common with USB enclosures and certain RAID controllers.

If several similar devices are connected, compare their physical locations and capacities, use controller-management information where available, or connect them individually.

When the correct physical target cannot be established with confidence, stop rather than proceeding with an uncertain selection.

Device marked as the system disk

DriveErase prevents selection of the disk containing the active Windows installation.

This is normal protective behavior rather than a detection failure. If you need to sanitize that disk, connect it as a non-system device to another compatible computer.

Do not attempt to bypass the protection or change critical boot settings merely to make the current system disk selectable.

Selection changes after refreshing

Refreshing the Device List can change the detected device order or Windows disk numbers.

After any hardware change, select the intended target again and review its identity and settings. Do not assume that a previously selected disk number still refers to the same physical device.

Device changes after restart

A drive can be detected correctly in Windows but appear differently in the Privileged Execution Environment.

This can happen if a USB device was disconnected, a storage controller presents devices in a different order, a drive was moved to another bay, or a virtual disk was replaced.

DriveErase may reject the prepared job when the target identity no longer matches.

Return to Windows, restore the intended hardware configuration, refresh the Device List, and create a new job after verifying the correct devices.

If the problem continues, record the device and controller details before contacting support.